How to take governor off ez go electric golf cart?

To take the governor off an EZ Go electric golf cart, follow these steps: 1. Locate the governor on your golf cart. It is typically located on the engine or near the throttle pedal. 2. Remove the cover or housing that is protecting the governor. This may require using a screwdriver or wrench to remove any screws or bolts. 3. Once the cover or housing is removed, locate the governor unit itself. It may be a small box or module. 4. Disconnect any wires or cables connected to the governor. This may require using a pair of pliers or wrench to loosen and remove any connectors. 5. Once all connections are removed, you should be able to physically remove the governor from the golf cart. Again, this may require using a wrench or pliers to loosen any mounting brackets or bolts. 6. Carefully lift the governor out of the golf cart and set it aside. 7. With the governor removed, you may need to adjust the speed settings or reprogram the controller to accommodate the increased speed. Consult your golf cart's manual or contact the manufacturer for specific instructions on adjusting the speed settings. Please note that modifying the governor on your golf cart may violate local regulations and may also affect the warranty of your golf cart. It is important to check with your local authorities and the manufacturer before making any modifications. Additionally, removing the governor may result in unsafe or unreliable operation of your golf cart, so proceed with caution and consider seeking professional assistance if you are unsure.