How to replace rear brakes on a 1995 ds club car golf cart electric?

Replacing the rear brakes on a 1995 DS Club Car golf cart is a relatively straightforward process. Here is a step-by-step guide to help you: 1. Safety first: Before you begin, make sure the golf cart is turned off and parked on a level surface. Engage the parking brake and chock the wheels to prevent any accidental movement. 2. Locate the rear brakes: The rear brakes on a 1995 DS Club Car golf cart are typically located on the rear wheels. Remove the wheel covers or hubcaps to gain access to the brakes. 3. Remove the wheel: Use a wrench or socket to loosen the lug nuts on the wheel. Once they are loose, lift the golf cart using a jack or lift and remove the wheel completely. 4. Remove the old brake pads: Once the wheel is removed, you will see the brake caliper. Use a wrench or socket to remove the caliper bolts and slide the caliper off the rotor. Take note of the position of the old brake pads. 5. Install the new brake pads: Take your new brake pads and place them in the same position as the old ones. Slide the caliper back onto the rotor and secure it with the caliper bolts. Make sure the bolts are tightened to the recommended torque specifications. 6. Reinstall the wheel: Once the new brake pads are installed, put the wheel back onto the golf cart and hand-tighten the lug nuts. Lower the golf cart back down and use a wrench or socket to fully tighten the lug nuts. 7. Repeat the process: Repeat steps 2-6 for the other rear wheel to complete the brake replacement on the 1995 DS Club Car golf cart. 8. Test the brakes: After replacing both sets of rear brakes, start the golf cart and test the brakes to ensure they are functioning correctly. Take a short test drive and listen for any unusual noises or vibrations. It is recommended to consult the owner's manual or a professional mechanic if you have any doubts or concerns during the brake replacement process.