How to remove the snap in speed sensor on my club car electric golf cart?

To remove the snap-in speed sensor on your Club Car electric golf cart, follow these steps: 1. Locate the speed sensor: The speed sensor is typically located near the rear axle on the electric motor. It is a small, cylindrical device that is connected to the wiring harness. 2. Disconnect the wiring harness: Carefully disconnect the wiring harness by gently pulling it away from the speed sensor. Be cautious not to damage the wires or connectors. 3. Release the snap-in mechanism: Examine the speed sensor and locate the snap-in mechanism holding it in place. This could be a small clip or a plastic tab. Use a screwdriver or a similar tool to release the snap-in mechanism and disengage it from the motor housing. 4. Remove the speed sensor: Once the snap-in mechanism is disengaged, you should be able to pull the speed sensor out of its mounting position. Take care not to damage the sensor or any surrounding components. Please note that the specific steps may vary depending on the model and year of your Club Car electric golf cart. If you are unsure or uncomfortable with performing the task yourself, it is recommended to consult the user manual or seek professional assistance.