How to change controlleron electric golf cart?

To change the controller on an electric golf cart, you will need to follow these steps: 1. Gather the necessary tools - You will need a wrench or socket set, wire cutters/strippers, and a new controller that is compatible with your golf cart. 2. Disconnect the power - Before you start working on the controller, make sure to turn off the power to the golf cart and disconnect the battery. 3. Locate the controller - The controller is usually located under the seat or in the front compartment of the golf cart. You may need to remove a cover or panel to access it. 4. Disconnect the old controller - Carefully disconnect all the wires connected to the old controller. Take note of the wire connections so that you can reconnect them correctly later. 5. Remove the old controller - Once all the wires are disconnected, use a wrench or socket set to remove any bolts or screws holding the old controller in place. Take out the old controller. 6. Install the new controller - Place the new controller in the same location where the old one was and secure it with bolts or screws. Make sure it is positioned correctly. 7. Connect the wires - Reconnect all the wires to the new controller, following the notes you took earlier to ensure the proper connections. Use wire cutters/strippers if necessary to strip the ends of the wires before reconnecting them. 8. Test the golf cart - After all the wires are securely connected, reconnect the battery and turn on the power to the golf cart. Test the cart to ensure that the new controller is working properly. If you are not comfortable with performing these steps, it is always recommended to consult a professional or refer to the manufacturer's instructions for specific guidance on how to change the controller on your electric golf cart.