How to change an ignition key on a e-cycle electric moped?

To change an ignition key on an e-cycle electric Moped, follow these steps: 1. Turn off the Moped: Before attempting any repairs or replacements, make sure the Moped is turned off and the key is removed from the ignition. 2. Locate the ignition assembly: The ignition assembly is usually located on the handlebars or near the steering column of the Moped. It consists of the ignition switch, key slot, and wiring connectors. 3. Remove the old ignition key: Insert the current ignition key into the key slot and turn it clockwise or counterclockwise to release the lock mechanism. Once the lock is released, pull the ignition key out of the slot. 4. Disconnect the wiring connectors: Look for the wiring connectors connected to the ignition assembly. Gently unplug or disconnect the wiring connectors from the assembly. Take note of the wire colors or mark them if necessary to ensure proper reconnection later. 5. Install the new ignition key: Take the new ignition key and insert it into the key slot. Turn it clockwise or counterclockwise to engage the lock mechanism and secure it in place. 6. Reconnect the wiring connectors: Take the wiring connectors that were disconnected earlier and reconnect them to the appropriate terminals on the new ignition assembly. Ensure that the connectors are securely attached and properly aligned. 7. Test the new ignition key: Turn on the Moped using the new ignition key to verify that it functions correctly. The Moped should power on, and the key should easily turn in the ignition switch. If you encounter any difficulties during the process, it is recommended to consult the manufacturer's manual or contact a professional technician for assistance.